1. Plug Sensor Cable into Sensor.
2. Clamp Sensor Cable into strain relief built into Sensor Mount bracket.
3. Use included hardware to mount VIBRA-SYNC™ Sensor close to motor or drive section in a free pan bracket spring mount hole.
4. Mount VIBRA-SYNC™ Node to machine base or structure by motor. The Node Mount bracket can clamp, weld, or bolt to structure.
5. Run Sensor Cable from Sensor to Node.
6. Plug Sensor Cable into the Node.
7. Route Sensor Cable away from moving parts and potential debris.
8. Affix cable to base or structure.
9. Mount the VIBRA-SYNC™ Hub in a location it can connect to Wi-Fi and to at least one VIBRA-SYNC™ Node. The Hub can be mounted to building columns, walls, or other structure.

Contact ACTION with questions about mounting locations and network range.

1. The VIBRA-SYNC™ Node can be powered from the conveyor’s motor power or an outlet. An electrician is required to connect the Node to power.
2. The VIBRA-SYNC™ Hub is powered with the included AC wall adapter.

1. Download the VIBRA-SYNC™ app from the iOS or Android store.
2. Ensure Bluetooth is enabled on your phone.
3. You will need to know the password for the Wi-Fi you are connecting the Hub to.
4. With Hub powered on, push and hold “WI-FI Reset” button until white LED turns off about 7 seconds.
5. The Hub will reset and the white LED will start to flash.
6. Open the VIBRA-SYNC™ app and navigate to the “SETUP” page of the app.
7. While the Hub’s white LED light is flashing, select “SETUP” button in the app.
8. Follow prompts in the app.
9. If the app reports success or the green LED light is on, the Hub connection is complete.
10. If you do not see a green LED light, the Wi-Fi password may be incorrect. Check password and try again.
11. If problem persists, try closing and restarting the app, hold “Wi-Fi reset” button, and follow connection instructions again.

Contact ACTION if you have trouble connecting the hub to your network.